Craftsman 580.752090 Operator's Manual page 15

Follow these instructions to change ProjectPro
1. Pull back collar on quick–connect and pull current
ProjectPro nozzle off. Store ProjectPro
®
holder provided on the accessory tray.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange ProjectPro
trigger lock on the spray gun.
• DO NOT twist ProjectPro nozzles while spraying.
®
2. Select desired ProjectPro
• For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select yellow
delicate ProjectPro
• For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways and
sidewalks, garage floors, etc., select orange general
ProjectPro ® nozzle.
® nozzles:
nozzles in
®
® nozzles without locking the
nozzle:
®
® nozzle.
• For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red max ProjectPro
nozzle.
3. Pull back on collar, insert selected ProjectPro
and release collar. Tug on ProjectPro
sure it is securely in place.
4. For most effective cleaning, keep ProjectPro
8 to 24 inches away from cleaning surface. If you get the
nozzle too close, you may damage the cleaning surface.
5. DO NOT get closer than 6 inches when cleaning tires.
How to Use the HydroFoam™ Launcher
The quick–connect on the nozzle extension allows you to
attach the HydroFoam™ launcher. Use the HydroFoam™
launcher to apply HydroFoam™ wash or other project specific
cleaners to help break down stubborn dirt and grime on a
variety of surfaces.
Follow these instructions to attach the HydroFoam™ launcher:
1. Pull back collar on quick–connect and pull current
ProjectPro nozzle off. Store ProjectPro
®
holder provided on the accessory tray.
2. Pull back on collar, insert HydroFoam™ launcher and
release collar. Tug on HydroFoam™ launcher to make
sure it is securely in place.
IMPORTANT: Also see the HydroFoam™ launcher and wash
instruction sheet for important instructions and uses.
Cleaning and Applying Detergent
Chemicals can cause bodily injury, and/or property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
15
®
® nozzle
® nozzle to make
® nozzle from
nozzles in
®
CAUTION