further half-turn. Make sure there are no kinks in the hose.
2. Turn the tap on and check for leaks. Check for leaks again after 24 hours.
The cold water temperature should not exceed 35°C.
Water Supply Requirements:
• Inlet water pressure: Maximum 1000kPa (150psi), Minimum 30kPa (4.5psi)
• Inlet water flow rate: Minimum 6 litres/minute
An internal heater in the product will heat the cold water to the selected cycle temperature.
Draining
Drain hose placement in a stand pipe or tub
1. To guide the drain hose over the tub or
standpipe the hose guide must be fitted to the
drain hose. The height of the standpipe or tub
should be between 800 – 1200mm.
2. Secure the hose guide so it cannot become
dislodged from the standpipe or tub.
https://producthelp.fisherpaykel.com/au/Wash/Front_Loaders/Washer_Dryer_Combo/WD8560F1/User_Guide_WD8560F1/03...
Updated: Sat, 15 Feb 2020 18:52:05 GMT
Powered by
7