Removing The Transit Bolts - Fisher & Paykel WD7560P1 Installation Instructions Manual

Asmall amount of water may be seen inside the packaging and inside the washer dryer. This is the
result of factory testing and is normal.
2. Tilt the product backwards and 'walk' it off the base one foot at a time. Not doing so may cause damage to your
floor and washer dryer.
3. Remove all packaging and accessories from inside the drum.

Removing The Transit Bolts

The clothes washer dryer is fitted with 4 transit bolts at the rear to prevent internal damage during transportation.
• The 4 transit bolts MUST be removed prior to operation of the machine. Failure to remove these
• Ensure packaging materials are kept out of reach of children.
• Please help protect the environment and dispose of the packaging from around the washer dryer
To Remove The Bolts:
1. Use a spanner or socket to unscrew and remove all four transit bolts at the back of the washer dryer (A).
2. Pull the black rubber grommets to remove the bolt, grommet and white plastic spacers from the machine. Keep
the transit bolts in case they are required for future transit of the machine. Never transport the machine
without the transit bolts properly fixed in place.
3. Cover the bolt holes with the white plastic plugs which are attached to the machine and located near each hole
(B). Push to clip into place.
https://producthelp.fisherpaykel.com/au/Wash/Front_Loaders/Washer_Dryer_Combo/WD8560F1/User_Guide_WD8560F1/03...
will result in damage to the product.
in an environmentally friendly manner.
Updated: Sat, 15 Feb 2020 18:52:05 GMT
Powered by
2