Preparation For Return Shipment; Ordering Spare Parts And Operating Supplies; Malfunctions - Samson 45-9 Mounting And Operating Instructions

Malfunctions

7.7 Preparation for return
shipment
Defective devices can be returned to
SAMSON for repair. Proceed as follows to
return devices to SAMSON:
1. Put the regulator out of operation (see
section 9).
2. Decontaminate the regulator. Remove
any residual process medium.
3. Fill in the Declaration on Contamination.
The declaration form can be downloaded
from our website at u www.samson.de >
SERVICE & SUPPORT > After-sales
Service.
4. Send the device together with the filled-in
form to your nearest SAMSON subsidi-
ary. SAMSON subsidiaries are listed on
our website at
u www.samson.de > About SAMSON >
Sales offices.
7.8 Ordering spare parts and
operating supplies
Contact your nearest SAMSON subsidiary
or the SAMSON After-sales Service depart-
ment for information on spare parts, lubri-
cants and tools.
36
8 Malfunctions
The malfunctions listed in Table 7 are caused
by mechanical faults and incorrect regulator
sizing. In the simplest case, the functioning
can be restored following the recommended
action. Special tools may be required for re-
pair work.
Exceptional operating and installation condi-
tions may lead to changed situations that
may affect the control response and lead to
malfunctions. For troubleshooting, the condi-
tions, such as installation, process medium,
temperature and pressure conditions, must
be taken into account.
SAMSON's After-sales Service department
can help during troubleshooting. Further in-
formation is available in section 10.1.
Note
Contact SAMSON's After-sales Service de-
partment for malfunctions not listed in the ta-
ble and when the malfunction cannot be
remedied as described.
Tip
SAMSON's After-sales Service department
can support you in drawing up an inspection
and test plan for your plant.
EB 3128 EN