Makita 2012NB Instruction Manual page 7

Provide a flat wood block approximately 300 mm (11-
13/16") long and 100 mm (3-15/16") wide. Place the
blade and the set plate on the wood block so that the
blade locating lug of the set plate rests in the groove of
the blade. Adjust the set plate so that both ends of the
blade protrude approximately 1 mm (3/64") beyond the
end of the set plate. Place the two magnetic holders on
the set plate and push them until the claw contacts the
blade.
1
2
► 1 . Magnetic holder 2. Set plate 3. Blade
Grip the magnetic holder and slip the heel of the set
plate into the groove in the drum. Install the blade instal-
lation bolts.
1
2
► 1 . Blade installation bolts 2. Set plate 3. Magnetic
holder 4. Drum 5. Blade 6. Claw
After tightening all the blade installation bolts lightly
and evenly from the center to the outside, tighten them
completely following the same sequence. Remove the
magnetic holders from the set plate.
1
► 1 . Socket wrench 2. Magnetic holders
3
1mm (3/64")
3
4
5 6
2
Install the other blade as described above. Rotate the
drum slowly while pressing the lock plate to make sure
there is nothing abnormal. Then install the chip cover
and the side cover.
CAUTION:
• Do not tighten the blade installation bolts without
the blade locating lug of the set plate correctly
resting in the groove of the blade. This may
cause damage to the blade and potential injury
to the operator.
• Do not turn the tool on with the chip cover
removed.
Hood set (optional accessory)
2
► 1 . Hood 2. Hood holder
When you wish to maintain clean operations through
easy dust collection, connect the vacuum cleaner to the
planer using this hood.
Attach the hood holder to the hood and secure with the
screws.
Loosen the thumb screws which secure the chip cover.
Attach the hood to the planer and secure the chip cover
and the hood together by tightening the thumb screws.
1
2
► 1 . Chip cover 2. Thumb screw 3. Hood
7 ENGLISH
1
3