Philips HP4883/00 User Manual page 7

Keep this appliance away from water! Do not use this product near
,
or over water contained in baths, washbasins, sinks etc. When used
in a bathroom, unplug the appliance after use since the proximity of
water presents a risk, even when the hairdryer is switched off.
For additional protection, we advise you to install a residual current
,
device (RCD) with a rated residual operating current not
exceeding 0mA in the electrical circuit supplying the bathroom.
Ask your installer for advice.
Keep the appliance out of the reach of children.
,
Never block the air grilles.
,
If the appliance overheats, it will switch off automatically. Unplug
,
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they
are not blocked by fluff, hair, etc.
Always switch the appliance off before putting it down, even if it is
,
only for a moment.
Always unplug the appliance after use.
,
Do not wind the mains cord round the appliance.
,
You may notice a characteristic odour when using this hairdryer.
,
This is caused by the ions that are generated and it is not harmful
to the human body.
Do not probe the ion generator with metal objects.
,
Noiselevel: Lc = 8 dB(A)
,
using the appliance
Drying
1 Put the plug in the wall socket.
 Switch the appliance on by selecting the desired airflow setting:
- Set the slide switch to airflow setting II for ultra-quick drying.
- Set the slide switch to airflow setting I for drying short hair or styling
your hair.
You can also use the Jet position of the JetSet switch for an extra-
,
powerful airflow. (Fig. 2)
EnglisH
7