Position The Media Gateway - Avaya S8700 Installing

With avaya mcc1 or scc1 media gateways
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Perform these tasks to install the media gateways:
''Position the Media Gateway'' on page 69
''Install Earthquake Protection for Media Gateway'' on page
!
WARNING:
If the approved ground or approved floor ground can only be accessed inside a dedicated
power equipment room, then connections to this ground should be made by a licensed
electrician. See
Approved
''Connect AC Power and Ground'' on page 72
page 81
''Connect Remote Power Off Cable'' on page 90
''Connect External Alarm Cable'' on page 92
Interconnect cabling between port networks
— Direct connect to rack hardware
— Direct connect to each port network (duplex and high/critical)
— Switch-connect to port networks (duplex and high/critical)

Position the Media Gateway

Each media gateway is normally positioned adjacent to the control hardware in the rack or
another media gateway.
NOTE:
Typically, the center stage switch is collocated with a port network (PN). It is not required
to be located in port network 1.
If the S8700 Multi-Connect configuration is supplied with cable ductwork, space the
1
media gateways on 32 in. (81.3 cm) centers +-1/8 in. (0.3 cm). They must be level and
must be square with respect to each other.
2
If the S8700 Multi-Connect configuration is supplied with cable slack managers, place
the media gateways far enough from the connection field to lay down the 32 in. (81.3
cm) slack managers and to provide a little extra room for the cables to access the cable
slack managers.
If earthquake protection is required,
3
on page
70.
If earthquake protection is not required, level the media gateways and adjust and lock the
4
media gateway stabilizing bolts to keep it from moving.
At the bottom of the media gateway, install the hole plugs provided in the holes
5
previously occupied by the 4 carriage bolts.
Grounds.
for more information.
or
''Connect DC Power and Ground'' on
''Install Earthquake Protection for Media Gateway''
May 2003
70, if required.
69

Advertisement

Table of Contents
loading

Table of Contents