Worktop Cut-Out Km 414 - Miele KM 404 Installation Instructions Manual

Dimensions 7 mm and 11 mm are the
space taken up by the frame of the
appliance on the worktop.
^ Make a cut-out for the hob in the
worktop.
Dimension "B" applies to a combination
of appliances and is shown on the
chart.
There must be a minimum safety
distance of 50 mm between the hob
and the back wall and 200 mm
distance from a side wall to the right or
left of the hob.
See also chapter "Warning and safety
instructions".
^ Seal the cut surfaces with a suitable
sealant to avoid swelling caused by
moisture.
The materials used must be heat
resistant.

Worktop cut-out KM 414

Worktop cut-out KM 414 / KM 417
Depth in mm
± 1 mm
1 Hob 500
Worktop cut-out KM 414 / KM 417 +
288 mm wide appliances
Number
of
appliances
KM 414 / 417 +1
KM 414 / 417 + 2
KM 414 / 417 + 3
KM 414 / 417 + 4
Important:
The maximum tolerance for the worktop
cut-out must not exceed ±1 mm.
When building in several combiset
appliances a spacer bar must be
fitted between each unit.
See chapter "Fitting spacer bars and
support brackets".
Narrow combiset appliances (288 mm
wide) can be installed to the left or right
hand side of the KM 414 / KM 417.
Width (= Dim B)
in mm
± 1 mm
552-560
Depth Width
(= Dim B)
in mm in mm
± 1 mm ± 1 mm
500 840
500 1128
500 1416
500 1704
17