Table of Contents
Advertisement
Access to Programming Mode
You can only enter the programming mode during an incoming call (from a phone to Lift1). Enter the
access password:
service password
If the password is correct and programming is enabled (jumper), Lift1 announces:
„You have entered the programming mode"
and displays a Help according to the context. The default password is 12345 and you are
recommended to enter a different password to protect your device against unauthorised persons.
Tips
•
If you forget your service password, use the programming tool and PC with 2N® Service Tool.
•
While entering the password, keep a timeout of 5 seconds (or any other value in the range
between 1 and 9) for each character to avoid Lift1 hang-up and password/parameter re-
entering.
Programming Procedure
Having entered the programming mode, you can change any programmable value(s) in any order.
Proceed as follows: enter the parameter number and value. Use an asterisk as a separator or Enter. In
general, the function has the following format:
Parameter number
The parameter number has three digits (see the table). After you enter the number and an asterisk,
Lift1 shall report the number/name, current value and potential range of the parameter to be
programmed. After you enter the value and another asterisk, Lift1 shall announce "New value stored",
or "Invalid value" if the value is beyond the allowed range.
Programming Error
•
If you make a mistake while entering a number (function or value) and find it before clicking
the asterisk, press
•
If Lift1 rejects a parameter number or value, you can go on programming – enter the function
number although you typed a wrong value.
•
If you have programmed and saved a wrong value, re-enter a correct value.
Programming End
•
Having saved all the values to be modified, press
hang up.
•
If you do not press
values are stored immediately in the memory).
•
If you are not quite sure of how Lift1 will behave after programming, check the functionality.
•
Save the filled-in form for later check.
•
Tip
•
Refer to the full User Manual for message recording, acoustic parameter setting, switch
programming and Lift1 Programming Tool details.
(remember to enter an asterisk in front of and behind the password!)
value
to cancel the whole number and enter a new one.
, Lift1 will hang up later without affecting the value saving process (the
to make Lift1 send an on-hook signal and
7
EN
Advertisement
Table of Contents
