Table of Contents
Advertisement
876 – End-of call
message language
selection
877 – Outgoing call
message language
selection
912 – Maximum call
time
913 – Login time limit
(for automatic dialing)
914 – Delayed call
916 – Cancel input
inversion
920 – Alarm button
mode
962 – Minimum
button pressing time
965 – Private mode
966 – Rescue process
0–9
1
0–99
1
15–990 s
120 s
10–990 s
60 s
0–1000 s
0 s
0-1
0
0-2
0
100–9999
100 ms
ms
0–25
0
0-4
0
4 = send identification by DTMF
5 = message as specified in parameter
977 (after confirmation according to
parameter 976)
6 = combine options 5 + 2
7 = confirmation tone (after confirmation
only)
0,3,5,7 =
1 = English (or other main language
depending on Lift1 version)
2 = English (or tones for English
version)
4 = German
6 = Polish
8 = Portugese
9 = Dutch
10 to 99 = silence
Use the call-extending command to
extend the call (DTMF 4 or *).
Set the maximum period of time for the
control centre staff to answer the call
and send confirmation, otherwise Lift1
hangs up and dials the next number.
Counted from the end of dialing.
Applied only if the CANCEL input is
connected.
0 = contact closed or voltage present at
opened door
1 = contact opened or voltage not
present at opened door
0 = normally open contact or voltage
present to activate
1 = normally closed contact or voltage
not present to activate
2 = autodetection, during the next boot
of the device the state of the input
will be set as not active state.
Applies to the ALARM button.
Incoming call permitted always during
rescue process. Parameter specifies
functionality when the rescue process
is not active:
0 – incoming call permited during
rescue process only.
1 – 24 – time after alarm, when
incoming call is permitted (hours)
25 – incoming call is always enabled
0 = disabled
1 = End of rescue process by Alarm 2
2 = End the rescue process by rescue
password
9
EN
Advertisement
Table of Contents
