Electronic Immobiliser - PEUGEOT 108 Handbook

If the vehicle is not immobilised, the
engine will not stop.
An audible signal sounds continuously when
you open the driver's door and the vehicle is in
"ACC" mode.
F Press the "START/STOP" button again to
go into "OFF" mode.
Back-up starting
When the electronic key is in the
recognition area and your vehicle
does not start after pressing the
"START/STOP" button, this warning
lamp flashes in the instrument panel.
F Vehicle with a manual gearbox: move the
gear lever to neutral.
F Vehicle with an ETG gearbox: move the
gear selector to N.
F Touch the "START/STOP" button with the
corner of the electronic key nearest the
light. A beep sounds when the electronic
key is recognised, and the vehicle goes into
"ON" mode.
F Vehicle with a manual gearbox: press the
clutch pedal fully down.
F Vehicle with an ETG gearbox: press the
brake pedal.
F Check that the "Keyless Entry and Starting"
system indicator turns green in the
instrument panel.
F Press the "START/STOP" button. The
engine starts.
If the engine does not start, contact
a PEUGEOT dealer or a qualified workshop.
Emergency switching off
In the event of an emergency only, the engine
can be switched off without conditions. To do
this, press for more than two seconds, or press
the "START/STOP" button at least 3 times in
quick succession.
In this case, the steering column locks as soon
as the vehicle stops.
Electronic key not
recognised
If the electronic key is no longer in the
recognition zone while you are driving or when
you request engine switch off (at a later stage),
an audible signal sounds to alert you.
F Press the "START/STOP" button for more
than two seconds or press it a minimum
of 3 times in succession if you wish to
force the engine to switch off (attention,
restarting will not be possible without
the key).

Electronic immobiliser

Locks the engine management system after the
ignition is switched off and prevents the vehicle
being started by force.
The key contains an electronic chip which has
a specific code. When the ignition is switched
on, the code must be recognised for starting to
be possible.
In the event of a malfunction, your vehicle will
not start.
Contact a PEUGEOT dealer or a qualified
workshop.
Do not make any modifications to the
electronic immobiliser system.
Driving
6
75