PEUGEOT 108 Handbook page 107

F Remove the valve cap from the tyre to be
repaired, and place it in a clean area.
F Connect the hose from the bottle of sealant
to the valve of the tyre to be repaired and
tighten firmly.
F Check that the compressor switch is at the
"O" position.
F Uncoil fully the electric cable, stowed under
the compressor.
F Connect the compressor's electric plug to
the vehicle's 12 V socket.
F Affix the speed limit sticker.
The speed limit sticker must be secured
to the interior of the vehicle in the driver's
field of vision, to remind you that a wheel
is in temporary use.
The tyre inflation pressures are given on
this label.
F Switch on the ignition.
In the event of a breakdown
F Start the compressor by turning the switch
to the "l" position until the pressure of the
tyre reaches 2.0 bars. The sealant product
is injected under pressure into the tyre;
do not disconnect the pipe from the valve
during this operation (risk of blowback).
If a pressure of 2 bars is not reached after
about 7 minutes, this indicates that the
tyre is not repairable; contact a PEUGEOT
dealer or a qualified workshop for
assistance.
F Place the switch in the "O" position.
F Disconnect the compressor's electric plug
from the vehicle's 12 V socket.
F Replace the cap on the valve.
F Remove the kit.
F Remove and then store the bottle of sealant.
8
105