Brake Fluid Level; Coolant Level - PEUGEOT 108 Handbook

Topping up the engine oil level
The location of the oil filler cap is shown in the
corresponding underbonnet layout view.
F Unscrew the oil filler cap to access the filler
opening.
F Add oil in small quantities, avoiding any
spills on engine components (risk of fire).
F Wait a few minutes before checking the
level again using the dipstick.
F Add more oil if necessary.
F After checking the level, carefully refit the oil
filler cap and the dipstick in its tube.
Engine oil change
In order to maintain the reliability of the engine
and emissions control system, never use
additives in the engine oil.

Brake fluid level

The fluid level should be close to the
"MAX" mark. If it is not, check the
brake pad wear.
Access to the tank
F Unclip the plastic cover, located at the
bottom of the windscreen, by pressing on
both tabs.
When you unclip the plastic cover, make
sure not to remove the seal.
Fluid specification
This fluid must conform to the manufacturer's
recommendations.

Coolant level

The level of this fluid must be
between the marks "FULL" or "F"
and "LOW" or "L".
Practical information
The check and top up must only be done with
the engine cold.
A low coolant level presents a risk of serious
damage to your engine.
When the engine is hot, the temperature of the
coolant is regulated by the fan.
In addition, as the cooling system is
pressurised, wait at least one hour after
switching off the engine before carrying out any
work.
To avoid any risk of scalding, unscrew the cap
two turns to release the pressure. After it has
dropped, remove the cap and top up.
The cooling fan may start after
switching off the engine: take care
with articles and clothing that might be
caught by the fan blades.
Fluid specifications
These fluids must conform to the
manufacturer's recommendations.
Screenwash fluid level
Top up to the required level when
necessary.
7
101