Reversing Camera - PEUGEOT 108 Handbook

Operating fault
If there is a fault, this warning lamp
(orange) comes on in the instrument
panel.
Contact a PEUGEOT dealer or a qualified
workshop without delay.
Detection may be disrupted:
- If the road markings are worn.
- If there is little contrast between the
road markings and the road surface,
- If the windscreen is dirty.
- In certain extreme weather conditions:
fog, heavy rain, snow, bright sunlight
or direct exposure to the sun (low sun,
leaving a tunnel, etc.), and shadows.

Reversing camera

The reversing camera is activated automatically
when reverse gear is engaged.
The reversing camera cannot, in any circumstances,
replace the need for vigilance on the part of the driver.
The visual feedback is only shown on the
touch screen, with an indication of the edge of
the rear bumper (red line 1) and the general
direction of the vehicle (blue lines 2).
It is normal to have a part of the number plate
showing in the bottom of the screen.
Never reverse while looking only at the
screen.
High-pressure jet wash
When washing your vehicle, do not direct
the lance at the lens of the camera from
a distance of less than 30 cm.
The field covered by the camera is limited:
objects very close to the bumper or below it are
not visible.
The wide angle lens of the camera distorts
the image on the screen: the distances seen
on the screen may be different from the real
distances. This distortion varies depending on
the load conditions of the vehicle and slope of
the road.
Clean the reversing camera regularly
using a soft, dry cloth.
Driving
6
91