Changing The Remote Control Battery; Reprogramming The Remote Control; Electronic Engine Immobiliser - PEUGEOT 407 2009 Manual

ACCESS
4
CHANGING THE REMOTE
CONTROL BATTERY
Battery ref.: CR1620/3 volts.
To change the battery, unclip the casing
using a coin at the notch.
If the remote control does not work
after the battery has been changed,
Do not discard the batteries,
they contain metals which are
harmful to the environment.
lection point.
64
REPROGRAMMING THE
REMOTE CONTROL
Switch off the ignition.
Switch the ignition on again.
ton immediately for a few seconds.
Switch off the ignition and remove
the remote control key from the
ignition lock. The remote control is
now working again.
ELECTRONIC ENGINE
IMMOBILISER
tem as soon as the ignition has been
switched off and therefore prevents
starting of the vehicle by anyone who
does not have the key.
The ignition key has an electronic chip
which has a special code. When the
ignition is switched on, the code must be
recognised for starting to be possible.
If the system does not function correctly,
the following indicator light comes on:

Electronic engine immobiliser

indicator light
It is accompanied by a message on
Your vehicle will not start.
Consult a PEUGEOT dealer.
If the keys are lost
trieve the key code and the transponder
code to order a replacement key.
Make a careful note of the
number on each key. The
key number is coded on the
label attached to the key.
If the keys are lost, a PEUGEOT
dealer can rapidly supply you with
new keys.
The high frequency remote control
is a sensitive system; do not ope-
rate it while it is in your pocket as
there is a possibility that it may un-
lock your vehicle, without you being
aware of it.
The remote control does not ope-
rate when the key is in the ignition,
even when the ignition is switched
off, except for reprogramming.
Do not operate the deadlocking
function if there is anyone inside
the vehicle.