EPPA2-KIT PARTS AND TOOLS PLEASE REVIEW these instructions before beginning the assembly and adjustment procedures. Check that all the parts and tools listed below were provided with your order. Contact your supplier if any materials are missing. Do not discard the packaging until content that the product operates to your satisfaction.
Page 3
MONITOR REMOVAL EPPA2-KIT Disconnect and Remove the Monitor from EPAA Single Arm System The monitor arm and its base components are reused when converting to a dual arm system. The first step in this process is removing the monitor from the monitor arm.
The base assembly must be removed and disassembled in order to remove the monitor arm. Follow the procedures below for the particular method used to attach the base to the worksurface. IMPORTANT: Recycle the single arm base assembly. Contact ESI Customer Service at 1-800-833-3746. Clamp Method 1.
MONITOR ARM REMOVAL EPPA2-KIT Grommet Method (continued) 1. Peel the clamp pad from the base and grommet mount plate. 2. Remove the grommet mount plate and grommet bolt. Use the 4mm Allen key to remove the three M6x12 flat head screws.
Page 6
EPPA2-KIT MONITOR ARM INSTALLATION Install the Monitor Arm and Other Components onto the Dual Arm Base Assembly • At the top of the dual arm base assembly, place the top bushing onto the protruding rim. Then insert the monitor arm that you removed from the single arm base assembly.
DUAL ARM BASE ASSEMBLY INSTALLATION EPPA2-KIT Base Assembly Attachment Methods Typically, you will use the same method to attach the dual arm base that was used to attach the single arm base. • Clamp method. The base assembly is clamped to a table or desk surface that is between "...
EPPA2-KIT DUAL ARM BASE ASSEMBLY INSTALLATION Grommet Method This method can be used for worksurfaces that have a grommet hole in an appropriate position. First, the grommet bolt and grommet mount plate are assembled to the base. Then, with the base assembly placed over the grommet hole, the grommet bar and grommet knob are used to secure the base assembly in position.
Page 9
MONITOR INSTALLATION EPPA2-KIT Attach Monitors to VESA Mounts There are two sets of four holes on each VESA mount. One set has holes 3.9" (100mm) apart, the other set has holes 3" (75mm) apart. Use the set that matches the holes on the monitor.
EPPA2-KIT ADJUSTMENTS Install Cable Covers • Install the upper cable cover with the monitor cable and power cord captured. Pull apart slightly the upper and lower ends of the cover to fit it over the mounting holes on the monitor arm.
Page 11
RANGE OF MOTION AND ALLEN KEY STORAGE EPPA2-KIT 180° 360° 360° 360° Allen Key Allen Key...