Moving The Keyboard - Lenovo 1723-8BX Installation And Maintenance Manual

CAUTION:
Pinch hazard. (L012)
b. Fully extend the console unit out of the rack.
c. Press in both release latches
d. Grasp both sides of the console unit and pull it completely out of the rack
e. Place the console unit on a table or other flat surface.

Moving the keyboard

To move the keyboard from the existing console unit to the replacement console unit, complete the following
steps:
Step 1. Carefully lift the flat-panel display to the full upright position.
Step 2. Remove the keyboard-and-mouse cable from the keyboard tray, and then remove the keyboard
from the console unit and set it aside.
Step 3. Place the replacement console unit on a table or other flat surface and make sure that the right side
of the unit extends approximately 76 mm (3 in.) over the edge of the surface. This will help you
route the keyboard-and-mouse cable more easily.
Step 4. Hold the keyboard near the keyboard tray and carefully route the keyboard-and-mouse cable down
through the keyboard tray cutout and up through the cutout that is behind the flat-panel display.
(See the following illustration.) Carefully pull the cable through the cutouts.
42
1U 18.5-inch Standard Console Installation and Maintenance Guide
1 .
Release latch
Release latch
2
.