Lenovo 1723-8BX Installation And Maintenance Manual page 43

Cable-management arm
Step 6. Unpack the replacement cable-management arm.
Step 7. Remove the two washers on the cable-management arm bracket and replace them with the new
washers that come with the replacement cable-management arm.
Step 8. Align the screw holes in the new cable-management arm with the bracket and secure it with the
screw that you removed in step Step 5 on page 32.
Step 9. If you removed the console unit from the rack, go to "Installing the console unit in the rack" on page
46 to complete the procedure.
Step 10. Route the cables that you removed in step Step 2 on page 32 along the new cable-management
arm and secure them along the way with the hook-and-loop fastener strips.
Step 11. Align the C-channel on the end of the cable-management arm with the bracket on the console unit.
Slide the C-channel onto the bracket until the cable-management arm thumbscrew aligns with the
hole in the bracket. Tighten the thumbscrew.
Screw
Washers
.
Chapter 4 Hardware maintenance information
33