Table of Contents
Advertisement
Slide-rail front
d.
Repeat steps to to attach the other outer slide-rail.
Step 11. Use a #1 Phillips screwdriver to remove the four screws that attach each inner slide-rail to the
console unit. Then, attach the corresponding new inner slide-rails to the unit, using the same
hardware. Make sure that you orient the inner slide rails correctly (see the following illustration).
Front
Step 12. Go to "Installing the console unit in the rack" on page 46 for instructions for reinstalling the console
unit in the rack, and then install any other devices that you removed from the rack.
Replacing the console unit
The procedures that are provided in this section to replace the console unit in the rack consist of the
following tasks:
1. Removing the existing console unit from the rack
2. Moving the keyboard from the existing console unit to the replacement console unit
3. Removing and replacing the outer slide-rails
40
1U 18.5-inch Standard Console Installation and Maintenance Guide
Rear
Hide quick links:
Advertisement
Table of Contents
