Table of Contents
Advertisement
• Bag with M5 clip nuts, M5 stability screws, and M5 shipping screws
You need the following tools to replace customer replaceable units:
• One #1 Phillips screwdriver (to install or remove the inner slide-rails)
• One #2 Phillips screwdriver (to unscrew the shipping screws from the rack if you move the rack to another
location; to replace the cable-management arm)
See the documentation that comes with your rack or console switch for more information about those
products.
Notices and statements in this document
The caution and danger statements in this document are also in the multilingual Safety Information
document. Each statement is numbered for reference to the corresponding statement in the Safety
Information document.
The following notices and statements are used in this document:
• Note: These notices provide important tips, guidance, or advice.
• Important: These notices provide information or advice that might help you avoid inconvenient or
problem situations.
• Attention: These notices indicate potential damage to programs, devices, or data. An attention notice is
placed just before the instruction or situation in which damage might occur.
• Caution: These statements indicate situations that can be potentially hazardous to you. A caution
statement is placed just before the description of a potentially hazardous procedure step or situation.
• Danger: These statements indicate situations that can be potentially lethal or extremely hazardous to you.
A danger statement is placed just before the description of a potentially lethal or extremely hazardous
procedure step or situation.
Console unit specifications
The following sections provide the console unit specifications.
Rail-to-rail depth measurements
The console unit fits in a rack with the front to rear rail dimensions as shown in the following table. The
console unit dimensions are measured outside-to-outside and are for racks with unthreaded and threaded
holes.
Table 1. Console unit rack post distances
Rack configuration
No console switch
Provision for a console switch
Rack post distances
613 - 909 mm (24.1 - 35.8 in.]
706 - 909 mm (27.9 - 35.8 in.]
.
3
Chapter 1
Introduction
Hide quick links:
Advertisement
Table of Contents
