ZENEC Z-R1030 User Manual page 20

1. GND wire (black)
Connect this wire to a suitable vehicle chassis ground
point.
2. Door contact wire (green)
Connect this wire to the automatic interior illumination system of your vehicle.
3. Battery +12V wire
Connect this wire to a permanent +12V power supply in your vehicle, or to the positive
pole of the battery.
4. ACC ignition wire (red)
Connect this wire to the ignition contact of your vehicle.
5. A/V In 2
For a permanent connection to an external video source you can nd the A/V In 2 wire
at the upper side of the roof mount monitor.
6. A/V Output
The A/V output is suitable for connection with an external monitor.
7. Inverter switch
This switch allows to tailor the roof mount monitor to be compliant with the door contact
of the vehicle. Default position is (+). If your vehicle deploys a ground switched door
contact layout, put this switch into (-) position.
8. A/V In 1
A/V In 1 can be found on the side of the roof mount monitor.
9. USB Port
10. SD card slot
11. Interior illumination switch.
20