Parameter Mode - Orientalmotor BXII Series Operating Manual

When using the product with the speed control mode
5.4 Parameter mode
Parameters relating to motor operation and control can be set. These parameters are saved in the driver.
Before setting parameters, read the "BXⅡ Series USER MANUAL" carefully to understand the basic operations,
functions and other details of the driver.
Note • Parameters have significant bearing on motor operation. Before setting any parameter, make
sure you fully understand the content of the parameter.
• If operations are limited by the edit lock function, parameters cannot be edited.
• If the value you have input is outside the setting range, "Error" will be displayed for 1 second. If
this error display appears, input a different value that falls within the setting range.
• If a non-existent parameter ID is entered, "id-Err" will be displayed for 1 second. Check the ID
and enter the correct one.
„ Parameter ID
„
There is a unique ID in each parameter. With the OPX-2A, set the parameter selecting the ID.
Timing for the setting value to become effective
When a parameter is changed, the timing for the new value to become effective varies depending on the parameters,
which are the following three types.
• Effective immediately
Executes the recalculation and setup immediately when writing the parameter.
• Effective after stopping the operation
Executes the recalculation and setup after stopping the operation.
• Effective after turning the power ON again
Executes the recalculation and setup after turning the power ON again.
Operation in the parameter mode
1. Use the
2. Press the
The display changes to the screen to select the parameter type.
3. Use the
4. Press the
The display changes to the parameter setting screen.
Top screen in the

parameter mode

Note • If the value you have input is outside the setting range, "Error" will be displayed for 1 second. If
this error display appears, input a different value that falls within the setting range.
• If a non-existent parameter ID is entered, "id-Err" will be displayed for 1 second. Check the ID
and enter the correct one.
„ Initializing parameters
„
Parameters saved in the driver can be restored to their initial values. Execute "Initialize parameters" in the copy mode.
For the operation, check the screen transitions of the copy mode on page 13, or "Initializing driver data" on page 27.
−20−
key to select the parameter mode.
key on the top screen in the parameter mode.
keys to select a desired parameter ID.
key.
Parameter selection
Enter the parameter ID
Use to navigate through the digits.
Use to increase/decrease the value.
Check the ID and setting range with the parameter list.