Orientalmotor BXII Series Operating Manual page 23

„ I/O test
„
Execute I/O test to check the connection status of the driver.
Top screen in the
I/O test
Each digit on the 7-segment LED display corresponds to a signal.
The LED is lit when the input signal is ON, and it is unlit when the input signal is OFF.
Use the keys to switch the ON-OFF state of the output signal. "
while " " is displayed when the signal is OFF.
• • Input monitor
IN8
• • External voltage monitor
„ JOG operation
„
The motor can be operated using the keys on the OPX-2A. The operation speed, acceleration/deceleration time
and torque will correspond to the values set in the "JOG operation speed" parameter (ID: 323), "JOG acceleration/
deceleration" parameter (ID: 324) and "JOG operation torque" parameter (ID: 2081) respectively.
The next example shows the display that appears when setting the rotation speed of the initial value to 300 r/min and
operating the motor in the reverse direction using the
is executed.
Top screen in the
JOG operation
The motor rotates in the forward direction while the
The motor rotates in the reverse direction while the
Note • During operation, the motor rotates at the specified operation speed while each applicable key
is pressed. Before executing operation, consider the status of the equipment and condition of its
surroundings to confirm thoroughly that motor rotation will not cause any dangerous situation.
• JOG operation cannot be executed while the FREE signal or STOP signal is being ON. Be sure
to execute after turning the signal OFF.
Input monitor
Output test
External
voltage
monitor
• • Output test
IN0
IN1
IN2
IN3
IN4
IN5
IN6
IN7
The voltage value input by the analog external
setter can also be checked.
Executing
When using the product with the speed control mode
" is displayed when the signal is ON,
OUT2
key. The rotation speed is displayed while JOG operation
key is pressed.
key is pressed.
OUT0
OUT1
−23−