V-fit AL16/1E Assembly & User Manual page 19

3 Attach both Footplates (55) to the Footplate Support Bars (59) using 2 x M10 x 45mm Hex Bolts
(56), 2 x M10 Flat Washers (58) and 2 x M10 Nylon Locknuts (57) for each Footplate.
Note : The Footplates can be fitted in two positions.
4
i. Connect the Footplate Bars (59 L/R ) to the Crank arms using 1 x Shouldered Bolt (52L/52R)
1 x Wave Washer (51) through the Footplate Support Bar Pivot Bracket
and into the Crank arms, then fit 1 x M13 Spring Washer (49) and 1 x M13 Nylon Locknut
(48L/48R) for each side to secure the complete assembly. Cap the M13 Nylon Locknut
with 1 x S18 Round Cap (47) for each side. (SEE NOTE)
ii. Fit 1 x S17 Round Cap (60) to the outside bolt head and fit 1 x S13 Round Cap (63) to the
inside Nylon Locknut as shown for each side.
Assembly
Note
Ensure that the Shouldered
Bolts are fully tight before finally
securing the Nylon Locknuts.
One Bolt is supplied with a
RIGHT HAND THREAD for the
RIGHT HAND SIDE and must
be fitted by turning CLOCKWISE.
The other Bolt is supplied with a
LEFT HAND THREAD for the LEFT
HAND SIDE and must be fitted by
turning ANTI-CLOCKWISE.
Page 19