Advertisement
Alignment Bolts
Assembly & Adjustments
LUBRICATION and MAINTENANCE
The moving pa
rts in your Manual Magnetic Elliptical Trainer are all
pre-lubricated at assembly and should not require further attention.
We recommend however that the trainer is used inside and stored in
a dry condition. To clean the metal and plastic components, a general
household cleaner can be used, but please be sure to dry the trainer and
any attachments before use.
HOW TO MOUNT and DISMOUNT
Hold the handlebar and stand on the foot platform. Start your training.
When you finish your workout, hold the handlebar and slow down your
speed. Once stopped, step off and onto the floor carefully.
DRIVE BELT and FLYWHEEL ALIGNMENT
It may be necessary at some stage to adjust the Drive Belt on
your Manual Magnetic Elliptical Trainer. This can be achieved by removing
the 8 pre-fitted Machine Screws in the Chain Guards.
Loosen the Flywheel Spindle Nuts on both sides and adjust the two
10mm Alignment Bolt Nuts. Please take care to adjust each side equally
to ensure that the Flywheel is kept in alignment and that there is
approximately 10mm of FREEPLAY on the Drive Belt when correctly
adjusted.
10mm
Page 15
Hide quick links:
Advertisement
