Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Diamond CSP/4
Summary of Contents for Diamond CSP/4
- Page 1 12/2010 Mod: CSP/4 Production code: 40800802EHL...
- Page 2 CUTTER CE of the line: C4 vv C6 vv C9 vv OPERATING AND MAINTENANCE MANUAL...
-
Page 3: Table Of Contents
INTRODUCTION 5.3 - SHARPENING OF ROTATING BLADES CHAP. 6 - ORDINARY CLEANING pag. 11 • This manual is meant to provide customers with any information on the 6.1 - GENERAL FEATURES machine and its specifications and the necessary operating and maintenance 6.2 - CLEANING PROCEDURE OF THE MACHINE instructions in order to guarantee the best possible use of the machine and 6.2.1 - cleaning of lid, rotating blade holder and basin... -
Page 4: Chap. 1 - Information On The Machine
CHAP. 1 - INFORMATION ON THE MACHINE mechanical protections (when the machine is working and for maintenance and cleaning operations), there are still RESIDUAL RISKS (EEC 89/392 point 1.7.2) that cannot be eliminated completely, these risks are mentionned in this 1.1 - GENERAL PRECAUTIONS •... -
Page 5: Chap. 2 - Technical Data
1.3.3 - CUTTER components TAB. n°1 - OVERALL DIMENSIONS AND TECHNICAL FEATURES FIG. n°1 - General view of the CUTTER Models U.m. C4 VV C6 VV C9 VV Length A Width B Height C Max. height C Bowl capacity Bowl filling level 2600 1100÷2600 2600... -
Page 6: Chap. 4 - Installation
3.2 - PACKAGE CHECK UP ON RECEIPT 4.3 - ELECTRIC DIAGRAMS If no external damage is evident on the package upon its arrival, open it and check 4.3.1 - Single-phase electric diagram that all the components are inside (see FIG. n°3). If the package has suffered rough handling, bumps or crashes, the carrier must be informed about any damage;... -
Page 7: Chap. 6 - Ordinary Cleaning
5.3 - SHARPENING OF ROTATING BLADES 1 Dial knob to set the number of WARNING: Follow the the instructions below to rotations; sharpen the two blades if they do not cut properly: 2 Start button “I”. 1 rotate the closing arm (1) so as to remove the lid 3 Stop button “0”. -
Page 8: Chap. 8 - Disposal Of The Machine
CHAP. 7 - MAINTENANCE 7.1 - GENERAL FEATURES Before starting any maintenance activity it is necessary: a) to disconnect the power supply plug from the socket to isolate the CUTTER from the electric circuit completely. b) if the CUTTER is a vv model, to set the speed dial knob to the “0” position. 7.2 - BELT The belt does not need to be adjusted.
Need help?
Do you have a question about the CSP/4 and is the answer not in the manual?
Questions and answers