Kenwood TS-890S In-Depth Manual page 30

05 ANTENNA CONTROL CIRCUIT
The photo below shows the display screens on the TS-890S and TS-590 with split transfer feature 1 enabled.
The quickest way to enter the split operation mode is to long-press the SPLIT button on the TS-890S until the
band direct key starts flashing. Next, push the frequency to offset for the transmitting call to enter the split mode for
simultaneous reception of two bands. The frequency to call will be received from TS-590.
Turn the RIT/XIT knob on the TS-890S to control the RX frequency of the TS-590 (TX frequency of the TS-890S).
Wiring will be required by individual users for audio signal output using the TS-890S and TS-590G. The illustration
is an example of inputting monaural signal output from each of the transceivers to the audio mixer of the sound
equipment, followed by turning PAN on the mixer (BAL in the case of a stereo mixer) to allocate the main and sub
signals to the left and right and distinguish the signals by listening through the headphone.
The respective audio levels can be adjusted using the sound mixer knob to configure the signals to the desired state
from MIX to complete separation.
26