Algo 8186 User Manual page 36

Sip horn speaker
Hide thumbs Also See for 8186:
Table of Contents

Advertisement

Action When Tamper Detected (Supervision)
In addition to the main events, the device can be configured with supervision to also
execute one of the above three actions in case the device goes offline due to wiring failure
or after being tampered with. For example, a tone could sound over the speaker(s), or a
private pre-recorded message could be sent to a specified phone extension. The
supervision configuration options will appear once a relay option with supervision is
selected. See the Electrical Specification section for details on supervision detection
circuit.
Extension to Dial
SIP account required in Page Extension fields in order to make a call. Can be configured if
'Make SIP Voice Call' or 'Make SIP Call with Tone' actions are enabled under 'Call Button
Settings'.
Interval Between Tones
Specify the time delay (seconds) between tones. Can be configured if Play Tone' or 'Make
SIP Call with Tone' actions are enabled under 'Call Button Settings'.
Maximum Tone Duration
Select the maximum tone duration. The tone will be terminated once the maximum time is
reached. Can be configured if 'Play Tone' or 'Make SIP Call with Tone' actions are
enabled.
Allow 2
nd
Button Press
If enabled, 2
nd
button press will either simply End Call or End and Restart Call. Therefore,
if an input is triggered for the second time (since the first input trigger enables one of the
four actions listed above) the SIP call will either simply be terminated or terminated and
immediately called again.
Outbound Ring Limit
Typically set to ensure that a call will not reach voicemail. This feature, under 'Outbound
SIP Call Settings', can be used to set a limit on how long the speaker will ring before
timing out.
Ring back Tone
If enabled, under 'Outbound SIP Call Settings', a ringback tone will play over the speaker
during an outbound SIP call, while waiting for the far-end party to answer.
Maximum Call Duration
Select the maximum call length. The call will be terminated once the maximum time is
reached. In the event that a call inadvertently reaches voicemail or gets accidentally left
on hold, this setting ensures that the 8186 returns on-hook.
Output Light
Enable/Disable the blue light on the speaker entirely (keep the light off even when the
speaker is active).
Document 90-00079B
03/24/2020
Page 36
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8186 SIP Horn Speaker FW 1.7
(604) 454-3792
support@algosolutions.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents