Mitsubishi Electric apricot XEN-LS Installation Manual page 8

Installation
Do not remove the memory module from its anti-static
wrapping until you are ready to install it. To install a
memory module:
1. Take suitable anti-static precautions as described in
the XEN-LS Owner's Handbook .
2. Switch off the computer and disconnect it from the
AC power supply. Remove the system unit cover,
the expansion card cage and the bridge assembly
as described in the XEN-LS Owner's Handbook .
3. Locate the memory module connectors by referring
to the following illustration and/or the layout
diagram inside the system unit.
4. If a lower-capacity module is already present, you
will have to remove it. Do this carefully as the
pins on the module are fragile and are easily
broken. Take hold of the module by its edges and
pull upwards with a firm but even force, keeping the
module horizontal at all times.
5. Remove the new memory module from its anti-static
wrapping. Take hold of the module by its edges, but
avoid touching its pins. Ignore any height extender
strips which may be included with the module; these
are not needed for XEN-LS machines.
6
MEMORY
MODULE
CONNECTORS
FRONT OF
MACHINE