Mitsubishi Electric apricot XEN-LS Installation Manual page 14

5. Plug either connector X or Y into the motherboard
as shown in the diagram opposite. Use connector X
if the 5.25" drive is to be drive A; use connector Y if
you want it to be drive B.
6. Refit the bridge assembly.
7. Remove a blanking plate belonging to a vacant slot
in the expansion card cage. If possible, use the
bottom slot.
8. Refit the expansion card cage, threading the end of
the ribbon cable out through the hole created by
removing the slot blanking plate.
9. Replace the system unit cover.
10. Using the second ribbon signal cable supplied in the
kit, connect the 5.25" drive to the end of the cable
which you have routed out through the card cage.
11. Using the power cable supplied in the kit, connect
the 5.25" drive to the DC outlet on the rear of the
system unit. (If you have an XP-i expansion box, the
DC outlet is needed to power the box. In this case,
use the auxiliary DC outlet provided in the side of
the XP-i box.)
12. Use the SETUP configuration software to declare
the presence of the new drive. (If you are upgrading
a diskless workstation, the network administrator
may do this for you, or else make a copy of the
SETUP software available over the network.) The
SETUP software is described in the Reference/
SETUP Diskette User's Guide .
12