Installing Connections; Power Supply; Connecting Rf Connectors; Installing The Narda Automatic Df Antennas - L3 Narda SignalShark 3320 Quick Start Manual

6

Installing connections

6.1

Power supply

The SignalShark 3320 is operated via an AC/DC adapter.
 Connect the AC/DC adapter to the DC power input of the
SignalShark 3320. If you use a screw connection, you must screw the
cable connector to the power input to ensure a reliable power supply.
 The device starts automatically when connected to the power supply.
6.2

Connecting RF connectors

Use the RF inputs (three RF SMA inputs + one RF N input) located on the
back of the SignalShark 3320 to connect RF connectors.
When using an RF SMA input:
 Connect the SMA plug to the SMA socket (see Figure 2: caption 1) and
carefully tighten the SMA connection with a torque wrench.
Exceeding the maximum torque
The SMA connection may be damaged, when exceeding the
maximum torque.
 Do not exceed the maximum torque of 0.6 Nm.
 Do not tilt and turn the cable while screwing.
6.3

Installing the Narda automatic DF antennas

The SignalShark 3320 is intended for use with the automatic DF antennas.
For the use of other Narda antennas as well as cables and antennas from
other manufacturers, refer to the operation manual. The operation manual
can be found on the USB device or in the SignalShark online help (for
details on how to access the online help, refer to Operating via the graphical
user interface (GUI) on page 34).
A detailed procedure on how to replace the RF cable on the Automatic DF
Antenna can be found in the Narda Automatic DF Antenna Handling and
Safety Instructions (3360/98.12).
Narda
NOTICE
SignalShark 3320 Remote Unit 29