Installing The Narda Directional Antennas - L3 Narda SignalShark 3310 Quick Start Manual

4.2 Operation with the charger/power supply device
Alternatively, operation with the supplied charger/power supply device is
optional. In practice, this procedure is not however recommended, because
when operating the 3310 with a connected charger/power supply device,
the measurement characteristics are significantly influenced by the
presence of the power cable in the field.
5 Installing the Narda directional
antennas
For the use of other Narda antennas as well as cables and antennas from
other manufacturers, please refer to the online operation manual. The
complete operation manual can be found on the device (see Request online
help on page 22).
5.1 Connecting the antenna handle to the base unit
The antenna handle has a fixed cable with two connections:
• Control connection (1): for power supply as well as for the transmission of
compass data and control signals
• N connection (2): for transmitting the RF signal
Picture 1: Connecting antenna handle: Control connection (1) and N connection (2)
Connecting antenna handle:
1. Place the control cable plug of the handle on the control connector of the
basic unit (1), so that the red marking on the plug points upwards and
forms a line with the slot in the control connector.
20
1 2
SignalShark Narda