Starting Up The Signalshark 3320; Switching The Device On And Off; Setting Up The Network Configuration - L3 Narda SignalShark 3320 Quick Start Manual

7

Starting up the SignalShark 3320

7.1

Switching the device on and off

 Make sure that all the connections have been made properly
(see Installing connections on page 29).
 Connect the AC/DC adapter to the DC power input of the device.
 The device turns on automatically.
 To switch the unit off, press the
shutdown, press the key for several seconds (5–10 seconds).
 To restart the device, press the
Displaying the operating status
The LED light (see Figure 1: caption 2) indicates the operating status:
• LED lights up green: Device is operational
• LED lights up red: Device is in initialization phase or an error occurred
7.2

Setting up the network configuration

For details on the possible connection types, refer to Setting up the device
control on page 31.
Automatic configuration
 The SignalShark 3320 is connected to a network using a DHCP server.
 The configuration parameter DHCP is set to ON by default.
 The IP address is automatically assigned to the SignalShark 3320 by
the DHCP server.
32 SignalShark 3320 Remote Unit
key for at least 0.5 second. For a hard
key again.
Narda