Switching On The Light - Sachtler TOPAS 110 Manual

Manual
DMX control:
Õ Connect the DMX cable to the light and to the DMX lighting
control console (DMX IN plug at the bottom of the TOPAS light,
Figure 8).
Õ Select the DMX start address (Figure 9).
Õ Set the operation mode switch Dim/DMX to DMX.
Figure 8
At the DMX OUT socket, a DMX can be daisy chained (looped
through) to other DMX devices. If the TOPAS light is the last device
in the DMX chain, you have to terminate it with an optional DMX
terminator.
9.6

Switching on the light

F
The fluorescent tubes reach their full luminosity after 1.5
minutes of operation.
Important
Õ Let the TOPAS light run at 100 % until it reaches its operating
temperature.
Õ Now you can set your desired dimming level.
- 15 -
TOPAS
Figure 9