Mounting The Ball Head; Mounting The Yoke - Sachtler TOPAS 110 Manual

TOPAS
9.2

Mounting the ball head

Õ Push in the ball-and-socket joint with the holding shoe at the
back of the lamp until it stops. (Figure 3).
á
The locking button must click in.
Õ Tighten the fixing screw. (Figure 4)
Figure 3
9.3

Mounting the yoke

Danger of accident
Õ
Only use original sachtler screws with integrated safety
Warning
device against accidental loosening.
Possibility of cable damage
The luminaire's cable can be kinked or crushed when adjusting
the yoke.
Note
Õ
Use suitable cord to fasten the cable.
Instead of the ball head, manual or pole-operated yokes can be
mounted to the TOPAS light.
Õ Using the four screws included, attach the yoke to the TOPAS
light (2 on each side) (Figure 5 and Figure 6).
Figure 4
- 12 -
Manual