Weidmuller IE-CS-2TX-1RS232/485 Hardware Installation Manual page 3

Appearance of the IE-CS(T)-2TX-1RS232/485
Appearance of the IE-CS(T)-2TX-2RS232/485
Reset to factory settings
To load the factory default settings depress the reset button for 5
continuous seconds. Use a pointed object, such as a straightened paper
clip or toothpick, to depress the Reset button. This will cause the Ready
LED to blink on and off. When the factory default settings are loaded
then the Ready LED stops blinking (after about 5 seconds). At this point,
you can release the Reset to default button.
- 3 -