Table of Contents
Advertisement
3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
– Do not remove the covers. Removing the covers of the laser product could result
in exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
– Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B
laser diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the
beam.
Attention: To avoid damage to your fiber-optic cables, follow these guidelines:
• Do not route the cable along a folding cable management arm.
• When attaching to a device on slides, leave enough slack in the cable so that it does not
bend to a radius smaller than 76 mm (3 inches) when extended or become pinched
when retracted.
• Route the cable away from places where it can be snagged by other devices in the rack.
• Do not overtighten the cable straps or bend the cables to a radius smaller than 76 mm
(3 inches).
• Do not put excess weight on the cable at the connection point and be sure that it is well
supported.
4
IBM Netfinity FAStT500 RAID Controller Enclosure Unit User's Reference
Advertisement
Table of Contents
