Troubleshooting - PNI Hunting 3C User Manual

Operation Humidity
Waterproof spec
Dimensions
Weight
6. Trouble Shooting
6.1 Photos Do Not Capture Subject of Interest
8) Check the "Sensor Level" (PIR sensitivity) parameter setting. For warm environmental conditions, set the
Sensor Level to "High" and for cold weather use, set the sensor for "Low".
9) Try to set your camera up in an area where no heat resources are in the camera's field of view.
10) In some cases, set the camera near water will make the camera take images with no subject in them. Try
to aim the camera over ground.
11) Try to set camera on stable and immovable objects, i.e.: large trees.
12) At night, motion detector may detect beyond range of the IR illumination. Reduce distance setting by
adjusting sensor sensitivity.
13) Rising sun or sunset can trigger sensor. Camera must be reoriented.
14) If person/animal moves quickly, it may move out of the camera's field of view before photo is taken.
Move camera further back or redirect camera.
6.2 Camera Stops Taking Images or Won't Take Images
6) Please make sure that the SD card is not full. If the card is full, camera will stop taking images. Or user
can turn on Cycle Recording to avoid such problem.
7) Check batteries to make sure that alkaline, or NiMH AA batteries left power is enough for camera to work.
8) Make sure that the camera power switch is in the "On" position and not in the "Off" or "Setup" modes.
9) When GPRS function is on, there will be around 1 minute interval for camera to send out photo before
camera shooting the next photo. Turn off the GPRS, camera can shoot photos continuously.
5%-90%
IP54
131.42 x98.72 x77.44mm
404g
- 50 -