Troubleshooting - Champion CHPM310 User Manual

Specifikations
Model Number:
Net Weight:
EN
Voltage:
Frequency:
Power:
Trouble shooting
Problem
Power connected.
Power button pressed.
The product does not operate.
During the first few operations,
a smell emanates from the
machine.
Abnormal vibration and noise.
"Creak" noise when the machi-
ne is in operation.
The control panel displays: "E0" 1. The dough is too dry.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources.
7
CHPM310
4,2kg
AC220V-240V
50Hz-60Hz
180W
1. The plug has not been fully
inserted.
2. Due to extended operation,
the machine has been automa-
tically shut down for protection.
This is a normal phenomenon
for new motors.
1. The extrusion rod is not in-
stalled correctly.
2. The noodle mold is installed
oppositely.
3. The locker is not screwed on
well.
The plastic seal inside the
kneading chamber is not
smooth enough.
2. Too much dough
Champion ®
Makadamgatan 14 I 254 64 Helsingborg I Sweden
info@championnordic.se
Designed in Sweden I Assembled in China
Analysis Trouble shooting
1. Make sure the power is pro-
perly connected.
2. Restart the machine after 20-
30 minutes.
If the smell persists after few
uses, contact customer service
center.
Check the extrusion rod, noodle
mold, locker and re-install them.
Add a drop of edible oil
to the plastic sel.
1. Put the dough again into the
kneading chamber, add an ade-
quate amount of water.
2. Reduce part of dough to
re-operate.