Display Messages - Mercedes-Benz GLE Hybrid 2019 Operator's Manual

Display messages

Hybrid drive system
Display messages
d
Vehicle Operational Vehicle Operational
Switch the Switch the Ignition Ignition
Off Before Exiting Off Before Exiting
Change the current Change the current
drive program drive program
before changing before changing the the
operating mode. operating mode. or
Exit manual drive Exit manual drive
program M before program M before
changing the changing the operat‐ operat‐
ing mode ing mode
E-MODE Currently E-MODE Currently
Unavailable Unavailable
Only E-MODE Availa‐ Only E-MODE Availa‐
ble Power Limited ble Power Limited
Refuel Immediately Refuel Immediately
Possible causes/consequences and M M Solutions
You are exiting the vehicle when it is in a ready-to-drive state. The
READY indicator in the multifunction display is on. A warning tone also
sounds.
If you leave the vehicle:
Secure the vehicle against rolling away (see the vehicle Operator's
X
Manual).
Switch off the ignition and remove the SmartKey.
X
If you do not leave the vehicle:
Switch off the electrical consumers, e.g. automatic climate control,
X
seat heating.
Please note the following: the electrical consumers are supplied by the
12 V battery. If the vehicle is left in a ready-to-drive state for an exten-
ded period, it will switch off once the 12 V battery is almost empty. It
will then only be possible to start the vehicle using a second battery
(jump-starting).
You have attempted to change the operating mode when in automatic
drive program Sport, Individual (with activated Sport characteris-
tics) or manual drive program M.
Select the Comfort, Slippery or Individual (with activated Com-
X
fort or Eco characteristics) drive program (
Select the preferred operating mode HYBRID, E-MODE, E-SAVE or
X
CHARGE ( page 21).
Y
The condition of charge of the high-voltage battery has dropped to the
lower limit and the E-MODE operating mode has been switched off.
Driving with the internal combustion engine is activated and the oper-
ating mode switches to the basic HYBRID setting.
Continue driving using the internal combustion engine.
X
You can switch to the E-SAVE or CHARGE operating mode as
required ( page 21).
Y
If you select CHARGE, the high-voltage battery is charged.
Once the condition of charge display for the high-voltage battery
has increased slightly, you can switch to the E-MODE operating
mode again.
The fuel tank has been run dry and the combustion engine has been
switched off.
A warning tone also sounds.
The vehicle will be powered by electrical energy only. Performance is
restricted and the vehicle may accelerate more slowly than normal.
You must refuel at the nearest gas station.
X
In the "Total range and electric range" menu, you can display the
approximate range of the vehicle (
Display messages
page 22).
Y
page 43).
Y
45
Z