Mercedes-Benz GLE Hybrid 2019 Operator's Manual page 36

Charging the high-voltage battery
34
Press and hold button = on the charging
X
cable connector and remove the charging
cable connector from the vehicle socket.
Close vehicle socket (
X
Remove the mains plug from the mains
X
socket and safely stow away the charging
cable inside the vehicle (
Charging the high-voltage battery
from the wallbox
General notes
It is recommended that you charge your vehicle
using a wallbox or at a charging station.
Make sure that the maximum charging current is
not limited in the
menu. You must select the maximum value if
charging at a wallbox or a charging station
( page 43).
Y
Pay attention to the important safety notes
( page 29).
Y
Connecting the charging cable
Shift the transmission to position j.
X
Switch the ignition off.
X
page 31).
Y
page 32).
Y
Sett. Sett. on-board computer
Open the vehicle socket (
X
Insert the charging cable connector into vehi-
X
cle socket : to the stop.
Indicator lamp ; first flashes orange and
then green.
The high-voltage battery is being charged.
If the charging cable is connected to the vehicle,
you cannot start the engine or move the vehicle.
As soon as the charging process begins, you can
display the charging prediction on the
board computer menu. The charging prediction
is either the anticipated condition of charge at
the programmed departure time or the time
when the high-voltage battery will be fully
charged ( page 44).
Y
i
Depending on the temperature, the fan and
battery cooling system may audibly switch on
during the charging process.
Removing the charging cable
The high-voltage battery is fully charged when:
the condition of charge display reaches 100%
R
in the multifunction display (
the indicator lamp on the vehicle socket lights
R
up green after unlocking or locking the vehicle
Press and hold button = on the charging
X
cable connector and remove the charging
cable connector from the vehicle socket.
Close the vehicle socket (
X
Charging the high-voltage battery at
the charging station
Before beginning the charging process at a
charging station without communication capa-
bilities, you must first activate the station, e.g.
page 31).
Y
Sett. Sett. on-
page 40)
Y
page 31).
Y