Fill The System; Bleed The Manifold; Clutch Drive Adjustment - Graco Lube Master Instructions Manual

Fill the System

Fill the pump package reservoir, as described in Fill the
Reservoir, page 9. After it is filled, the remainder of the
system is filled by attaching a hand pump to the system
downstream from the pump manifold block assembly,
then cycle the hand pump until the system is filled.
F . 7: Clutch Lever Diagram
IG
3A2781B
Clutch Drive Adjustment (if
equipped)
The clutch lever throw is adjustable between 12 and 60
degrees. Table 1 (page 12) provides the minimum/maxi-
mum pump outputs. The actual pump output of the
installation is computed using the Calculating Pump
Output procedure found on page 12.
Use the clutch lever diagram (F
anticipated clutch lever throw angle.
Setup
. 7) to determine the
IG
11