4. Adaptation of the supporting tube to roof pitches up to 10°
4.1
Adjustment of the adapter
The adapter of the tripod allows to adapt isolated air-termination systems with a diameter of 50 mm.
It compensates roof pitches or ground inclinations up to an inclination angle of 10° (see Fig. 7, page
11).
Depending on the alignment of the inclination angle, the supporting tube with air-termination tip is
inserted into the adapter and tightened by means of the four M10 locking screws.
In this process, the four hexagon nuts must be tightened against the adapter. The specified tightening tor-
ques must be observed (see Fig. 6, page 10 and Fig. 7, page 11).
supporting tube
Ø 50 mm
max. 10°
max. 10°
tightening torque
M10 locking screw; 25 Nm
hexagon nut
Fig. 6 Adjustment of the adapter
10