Wireless Remote Control; Inserting The Batteries - Panasonic CS-W14BB4P Operating Instructions Manual

5. WIRELESS REMOTE CONTROL

CZ-RL51P is used for Heat Pump models.
CZ-RL01P is used for Cooling models.
Wireless
remote control

5-1 Inserting the batteries

1
Slide the remote control cover, then pull out
the cover.
2
Insert the batteries.
(Use two R03 (AAA) dry-cell batteries or
equivalent.)
Make sure that the polarities are correct.
3
Close the remote control cover.
NOTES
• If the remote control cannot operate the unit properly or if the remote control display is weak, replace the batteries and then
repeat the settings. (Replace both batteries of the same type at the same time.)
• Remove both batteries from the remote control if not in use for a long period of time.
• Rechargeable (Ni-Cd) batteries differ in aspects such as shape and performance cannot be used.
When a signal is received from the wireless remote control, the
indicator on the ray receiver flashes.
OPERATION
TIMER
FILTER
Ray receiver
NOTES
• Direct the wireless remote control towards the ray receiver to operate.
• Operation is possible at distance of 8 m or less from the ray receiver. (The
operating range will be reduced if the wireless remote control is at a sharper
angle to the ray receiver.)
• Do not install the ray receiver in places exposed to direct sunlight or near a
heater.
• Make sure the signal of the wireless remote control to the ray receiver is not
obstructed.
– 10 –
OPERATION
TIMER
FILTER
The indicators flash in order several times.
Batteries
Remote
control cover
OPERATION
TIMER
FILTER