Subscribe to Our Youtube Channel
Related Manuals for Allnet ALL168208
Summary of Contents for Allnet ALL168208
-
Page 1: Quick Setup Guide
Powerline ALLNET ALL168208 200Mbps Powerline 4-Port HUB Powerline Network Instant Networks for Internet Access…and More! Solution for SOHO, S MALL FFICE AND FFICE QUICK SETUP GUIDE ALLNET GmbH – www.allnet.de © 2007 . All rights reserved. Page 1... - Page 2 Powerline REFACE This document describes installation of the ALLNET ALL168208. Please read this document before installing the product. O THE NSTALLER This publication contains the following sections: Important safety instructions The first thing you need to know before you begin to install...
-
Page 3: Important Safety Instructions
If the product has been exposed to rain or water. If the product does not operate normally when the operating instructions are followed. If the product exhibits a distinct change in performance. ALLNET GmbH – www.allnet.de © 2007 . All rights reserved. - Page 4 Pentium® 166 MHz processor, equivalent or higher Resource on your PC At least one free Ethernet port for ALLNET ALL168208 2. Your PC must not be configured for another network. This means that: No network clients except for Microsoft Network*, Client for Netware* Networks, or Microsoft Family...
- Page 5 Use the Category 5 Ethernet cable to connect the ALLNET ALL168208 and your PC’s Ethernet port. You can repeat steps 2 to connect another PC. Insure that all cable connected properly. Turn on the power by attaching the power cord to ALLNET ALL168208 and plug in the power outlet.
- Page 6 To install for the PC local Powerline network Follow the section “ “, to connect your PC to the ALLNET ALL168208. You will be able to access the Internet from anywhere through the power line or wireless by using ALLNET ALL168208.. ALLNET GmbH –...
- Page 7 As wireless AP (Access Point) Extender Connect the other Ethernet port to the AP Plug the Ethernet cable into the any RJ45 connector of the ALLNET ALL168208and plug the other end of the cable into the Ethernet port on the AP.
-
Page 8: Specification
STATION, the LED indicator will flash to indicate transmit or receive powerline activity. If the device is serving as a CCO, the LED indicator will light steadily ON, even in the presence of powerline activity ALLNET GmbH – www.allnet.de © 2007 . All rights reserved. -
Page 9: Reset Button
Press and hold: Press and hold button for more than 10 seconds and the device reverts to the “previous firmware version” including “previous firmware version” factory defaults. Device resets after change is made. ALLNET GmbH – www.allnet.de © 2007 . All rights reserved. - Page 10 The safety advice in the documentation accompanying the products shall be obeyed. The conformity to the above directive is indicated by the CE sign on the device. The ALLNET ALL168208 (200 Mbps PLC Switch Hub) conforms to the Council Directives of ALLNET GmbH – www.allnet.de ©...
- Page 11 This equipment is intended to be operated in all countries. This declaration is made by ALLNET Computersysteme GmbH Maistr. 2 82110 Germering and can be downloaded from http://www.allnet.de/ce-certificates/. ALLNET GmbH – www.allnet.de © 2007 . All rights reserved. Page 11...
Need help?
Do you have a question about the ALL168208 and is the answer not in the manual?
Questions and answers