Dometic CRX 1050 Installation And Operating Manual page 25

CRX1050, CRX1065, CRX1080
8.3 Releasing the lock
A
NOTICE!
Only adjust the locking mechanism when the door is open. If you
use it with the door closed, you will damage the device.
The refrigerator has a locking mechanism (fig. d 1, page 8) which is also
used to protect it during transport. The following settings are possible:
 Lock (turn wheel clockwise to the end stop): The door is locked and
secured.
To open the door, lift the handle up and open it.
 Vent (turn wheel anti-clockwise to the end stop): The door is slightly ajar,
but fixed in position.
Use this position if you are not going to use the appliance for a long time.
8.4 Switching off and storing the refrigerator
If you do not intend to use the refrigerator for a long time, proceed as follows:
➤ Press the on/off button until the refrigerator switches off.
➤ Disconnect the connection cable from the battery or disconnect the plug
on the AC cable plug from the rectifier.
➤ Clean the refrigerator (see chapter "Cleaning and maintenance" on
page 26).
➤ Turn the locking wheel (fig. d 1, page 8) anti-clockwise to the end stop
("Vent").
➤ Close the door until it latches in place.
✓ The door stays open and therefore prevents odours from forming.
8.5 Change the fuse
If the fuse in the AC socket is faulty, it can be replaced.
➤ Lever the fuse compartment (fig. c 3, page 8) open with a screwdriver.
➤ Replace the fuse (250 V/4 A).
➤ Close the fuse compartment again.
EN
Using the refrigerator
25