Dometic CRX 1050 Installation And Operating Manual page 19

CRX1050, CRX1065, CRX1080
7.3 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in fig. 8, page 6 to fig. 0, page 7 to change the hinges.
7.4 Connecting the refrigerator
Connect the refrigerator to DC power
A
NOTICE!
 To avoid voltage drops and loss of performance, keep the
connection cable as short as possible and avoid any additional
circuits.
Therefore avoid additional switches, plugs or power strips.
 Disconnect the appliance and other electric consumers from
the battery before you connect the battery to a quick charging
device. Overvoltage can damage the electronics of the appli-
ance.
The refrigerator can be operated with a 12 V or a 24 V DC voltage supply.
For safety reasons, the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against
reversed polarity when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage
is insufficient (see table below).
Cut-off voltage
Cut-in voltage
➤ Determine the required cross-section of the cable in relation to the cable
length according to fig. a, page 7.
Key for fig. a, page 7:
Coordinate axis
l
∅
EN
Installing and connecting the refrigerator
12 V
10.4 V
11.7 V
Meaning
Cable length
Cable cross-section
24 V
22.8 V
24.2 V
Unit
m
mm²
19