Alarm Time Setting; Temperature And Humidity Display - Bresser 70-01800 CM3000 Instruction Manual

DOWN, are disabled. In this case press and hold the
DOWN button (11) for approx. 5 seconds until the
symbol disappears. Automatic signal reception
is now disabled.
1. Press and hold the SET button (6) in normal time
display mode for approx. 3 seconds to change to
time setting mode. Year figure flashes.
km/h
2. Press the UP (10) or DOWN button (11) to change
the value.
3. Press the SET button (6) again to switch to the
next setting.
4. Repeat steps 2 and 3 to set other values in the
following sequence: Month > Day > 12/24 hour
mode > time zone (+/- 12 hours) > Hours > Min-
utes
5. After setting the value for the minutes press SET
button (6) again to save and exit time setting.

Alarm time setting

1. Press SET button (6) once switch to alarm time
display. The currently selected alarm time will be
displayed with AL.
2. In alarm time display mode press and hold SET
LED
button (6) for approx. 3 seconds to switch to
alarm time setting mode. Hour figure flashes.
2. Press the UP (10) or DOWN button (11) to change
the value.
3. Press the SET button (6) again to switch to the
next setting.
4. Repeat steps 2 and 3 to set other values in the
following sequence: Minutes > Snooze interval (1
to 20 minutes)
5. After setting the value for the snooze interval
press SET button (6) again to save and exit alarm
time setting.
NOTE!
Press the SNOOZE button when the alarm sounds
to interrupt the alarm for the desired snooze inter-
val. Press any button, except SNOOZE, to stop the
alarm.

Temperature and humidity display

After inserting the batteries indoor humidity (3) and
indoor temperature (4) will be displayed. After first
GB
19