Tuning To Radio Stations; Setting The Alarm Mode - Philips AJ301D/12 User Manual

3. Hold down or press ¡1 / 2™ repeatedly to set and adjust the hours.
4. Press TIME SET to confirm.
™ The clock digits for the minutes flash.
5. Repeat the steps 3 - 4 until you complete all the other settings for minutes,
year, month and days.
TUNER
1 Press TUNER/AUX once to switch on the radio (FM only).
™ Display shows the radio frequency of the last selected waveband. Your
preset station is also shown if you are listening to a preset. (See 2)
2 Adjust the sound using VOL+/-.
3 To select preset stations, press the respective PRESET button (1-5).

TUNING TO RADIO STATIONS

1 Press and hold ¡1 / 2™ until the frequency in the display starts changing.
™Display shows "Scrh" during automatic tuning.
™After the system tunes to a station of sufficient reception, display shows its
frequency.
• To tune to a weak station, press ¡1 / 2 ™ briefly and repeatedly until an
optimal reception is found.
To improve reception (FM):
Extend and position the pigtail fully to obtain optimum reception.
STORING AND USING PRESET STATIONS
You can store up to 5 FM radio stations in the memory.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2 To store a preset, hold down briefly on a PRESET button 1-5 until you hear a
double beep.
™ Display shows the preset number of your station.
3 Repeat steps 1 and 2 to store your other stations.
• You can overwrite a preset station by storing another frequency in its place.
4 Press a PRESET button 1-5 (or PRESET 4 / 3 on the remote control) to listen
to a preset station.
™ To display clock time, press 2; on the set.
USING THE ALARM
GENERAL
Two different alarm times can be set. This can be useful when you need to be
woken up at a different time e.g. during the week and at the weekend, and you
can set different wake-up modes:
• tuner mode.
• buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds.
• dock mode.
SETTING THE ALARM TIME (See 3)
1 In any mode, press and hold ALM1 or ALM2 for two seconds.
™ ALM1 / ALM2 icon and the hour digits flash. And the icon for the current
alarm mode also flashes.
2 Hold down or press ¡1 / 2™ repeatedly to set and adjust the hours.
3 Press ALM1 or ALM2 to confirm.
™ ALM1 / ALM2 icon and the minutes digits flash. And the icon for the
current alarm mode also flashes.
4 Hold down or press ¡1 / 2™ repeatedly to set and adjust the mintues.
5 Press ALM1 or ALM2 to confirm.

SETTING THE ALARM MODE

1 Press POWER to switch to standby mode.
2 Select your choice of alarm mode: either docked player, buzzer, or radio by
• •
using the DOCK BUZZER TUNER slider.
• At the set alarm time, the docked player or radio or buzzer will switch on
automatically.
Helpful hints:
– If you have selected TUNER alarm mode, make sure you have properly tuned to a
station before turning off the set.
– If you have selected DOCK alarm mode, make sure you have docked the compatible
player, or the buzzer mode will be selected automatically.
– To check the alarm time setting for ALM1 or ALM2, press ALM1 or ALM2.