Page 4
– 1 X AC/DC 18V adapter – Docking kit • 1 X Apple iPod dock (pre-installed with AJ300D);1 X Philips GoGear jukebox dock; • dock adapters (8 adapters for different iPod types, and 4 adapters for different Philips GoGear types) –...
Page 5
0 Display – shows clock/alarm times and status of the set ! Dock connector (30 pins) – connects iPod/Philips GoGear player ALM 2 – activates/confirm ALARM 2 time setting – displays ALARM 2 time –...
Page 6
Remote control Important! • Before using the remote control, remove the insulation plastic tab as shown in the figure. • If the remote control does not function correctly or the operating range is reduced, replace the battery with a new (CR2025) type battery.
BASIC OPERATION. Switching on the system • Press POWER. ™ The system will switch to the last selected source. • Press TUNER/AUX or DOCK. ™ The system will switch to the selected source. Switching the system to standby mode • In any source mode, press POWER. Switching off the volume temporarily Press MUTE on the remote control to stop sound play-back instantly.
• tuner mode. • buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds. • dock mode (only for Apple iPod and Philips GoGear SA9100 and SA9200)
DOCK BUZZER TUNER slider. • At the set alarm time, the docked player (only for Apple iPod and Philips GoGear SA9100 and SA9200) or radio or buzzer will switch on automatically. Helpful hints: – If you have selected TUNER alarm mode, make sure you have properly tuned to a station before turning off the set.
• Press ALM 1 or ALM 2 button once or more until ALM1 or ALM2 disappears. DOCK (See 4) By connecting the iPod/Philips GoGear to your AJ300D, you can listen to the sound of the docked player through the powerful speakers of the Hi-Fi system.
20GB, 40GB, 20/30GB photo, 40/60GB photo, 30GB video, 60GB video, miniand nano. • For the Philips GoGear dock, 4 dock adaptors of different type are included. Each adaptor is marked a number from “1” to “4” at its back. These numbers indicate the fit Philips GoGear players as follows: “1”...
charge the iPod/GoGear in the standby mode and power-on mode of AJ300D. SLEEP This set has a built-in sleep timer, which enables the radio to be automatically switched off after a set period of time. There are five sleep time options. Setting and switching off SLEEP 1 Set your timer by pressing SLEEP repeatedly until the desired timer option appears.
MAINTENANCE & SAFETY • Install the unit near the AC outlet and where the AC power plug can be easily reached. • The apparatus shall not be exposed to dripping or splashing. • Do not expose the set to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
To navigate the menu, use the controls on the docked player. – Some buttons on AJ300D and its remote control have no function. • The buttons ( 2;, ¡1, 2 ™ and VOLUME ) function only. For Philips GoGear, fast forwarding/rewinding is not available.
ENVIROMENTAL INFORMATION All unnecessary packaging material has been omitted. The packaging can be easily separated into three materials: cardboard, polystyrene and plas- tic. Your set consists of materials which can be recycled if disas- sembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment.
Page 16
Clock radio Meet Philips at the Internet http://www.philips.com English Printed in China PDCC-JH-AZ-0645...
Page 17
Notes for iPod connection 1. The docking entertainment system is compatible with all the existing Apple iPod models with 30-pin connector. 2. Four adaptors are included to fit different iPod models including iPod touch (8GB, 16GB), iPod classic (80GB, 160GB), iPod nano 3rd generation (4GB, 8GB), iPod the 5th generation (30GB, 60GB, 80GB), iPod nano 2nd generation (2GB, 4GB, 8GB) and iPod nano 1st generation (1GB, 2GB, 4GB ).